This is great option for those building their own 07k harnesses and looking to save time; or for those looking to clean up their factory harness. We can supply a matching female connector and terminals or a pre-terminated flying lead so this can easily and seamlessly replace the factory injector loom. As always full documentation of materials and a complete pinout is supplied. These are included with all our ecumaster, maxxecu, and fueltech harnesses. Standard lead time is 2 weeks.
 
Deutsch connector disconnect allows the intake manifold, fuel rail, or even the whole motor to be removed without unplugging each injector using a central disconnect increasing serviceability.

We offer this with varying options to suit your taste and build, below is a breakdown of each one.
 
Wire Choice
TXL is an high quality economical choice suited for automotive enviroments.
TEFZEL is a higher temp, smaller diameter, and more flexible alternative.

Loom
Braided is a motorsports grade loom; insultherm.
DR-25 is a lightweight, heat shrinkable tubing suitable for the motorsports world made by Raychem.
NO LOOM; you add your own split loom, tesa tape, etc. Harness is bound with kevlar binder to keep it tidy and ready for you.
 
Secondary Injectors
Naturally these are setup for 5 sequential injectors but if desired we can pin for 5 additional batch fired secondary injectors. For a grand total of 10 injectors. 5 sequential, 5 batch fired.
 
Labels
We offer these with or without labels. We use yellow MS23053/5 milspec grade labels covered in Raychem RT-375 clear heat shrink.
 
Injector Boots
We offer these with or without boots on the connectors. We use Raychem and Prowire products for boots.